What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 25.06.2025 05:01

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
In schematic diagrams this is the symbol for a fuse:
When did Elon Musk fall from grace?
One is “what exactly is in a ‘surge protector’ ? ”
The third is lightning and “how it gets conducted into a home.”
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
eight
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It also is a device that limits the change in current flow.
2024–10–16 [ OO OLAOYE OYEBODE ]
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
Qui omnis et eius rerum et dignissimos vel.
This one hit behind the barn.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Because the load is inductive, the current lags the voltage.(by a bit).
Nvidia and Perplexity Team Up in European AI Push - WSJ
The bolt then partially travels down the line to your home.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is where this question deviates from being a 'generic' question, and becomes more specific.
I’m 17 and looking for a girl. What do I do?
But… the neutral is now “floating” because of the 1 ohm resistance.
the problem then depends on "how fast does the fuse operate?".
First Sentence:
Rare Red Sprite Photographed in Tibet Dazzles Social Media - PetaPixel
The other is “what does a “fuse” do?”
Now when you have a certain ac resistance, then a current flows in a loop.
but this device (an Inductor) … impedes the rapid changes in the current.
Upvotes:
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
It seems Mohan does not understand the difference between a comment and an Answer.
Exploding battery fears spark recall of 1.1 million portable chargers - San Francisco Chronicle
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
what exactly is a ‘surge’ protector?
This is where the MOV conducts again, and dissipated the energy.
NASA KSC Announces COMET Staff RIF (Update) - NASA Watch
[image of Common-mode choke]
[old diagram got deleted by accident]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Is the Las Vegas Grand Prix considered one of the "premier events on the Formula 1 calendar?"
Edit 2024–10.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
but I think this circuit , shows a few more pieces.
He then describes the function of a fuse.
For this case there are devices called Metal oxide varistors (MOV).
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
These devices are installed between the “hot” and “neutral” and protective ground.
These are simplified answers to the original question, and does not change anything I wrote above.
But it can get overloaded, and no longer works.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
This device then solves the entire problem.
The MOV will conduct when the voltage exceeds 50% of line voltage.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
a photo is worth a thousand words.
2024–10–14 [Omar Gharbi Omar Gharbi ]
An AC voltage/ current source, and an ac inductive load.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
There are three different concepts here that are getting confused.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
At one ohm, the resistor has a maximum of 1 watt power.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
He then asserts :
(Dc diagram shown, AC is similar).
A circuit breaker is similar, but is resettable.
So, the voltage could go up to 500 volts, and the fuse will not open up.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
What does a fuse do?
2024–10–10[John johnson John Johnson ]
What is lightning?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
nine
This is the picture of an electronic coil of wire wound around a core of magnetic material.
One
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Barnstars:
There are two important concepts here.
Here is a simplified AC power diagram.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
I post the exact comment here.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
He then describes Rainy Season and Lightning.
This is 'the assistant's answer'
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
A fuse is a non-resetable over current circuit protector.
so, what happens?
At least they know the answer if they wanted it.